Publicidad
Idiomas disponibles
Idiomas disponibles
(continued)
INTERVAL /
MOTOR HOURS
Clutch stop
Knuckle pins
Front wheel bearings
Servo-control
Electronic switches
Electrical system
Mowing deck gearboxes
Pedals
Steering wheel joint
Travel pump
Knuckle pin axial bearing
Fuel injectors
Travel pump
Apart from regular maintenance according to the above table, it is necessary to replace motor oil based
on the recommendations in the manual drawn up by the engine manufacturer, which is included with
the riding mower.
6.2 INSPECTIONS AND MAINTENANCE BEFORE AND AFTER USE
BEFORE COMMENCING WORK
Before commencing work, always perform the inspections specified in
OUT. Inspections include the following tasks:
- check the fuel level
- check the air pressure in the tyres
- check the motor oil
- check the hydraulic transmission bypass
- check cables and bolt connections
- check the fuel system
- check the working order of the safety elements
- check the working order of the brakes
●
○
○
○
5.3 INSPECTIONS BEFORE RIDING
138
●
●
○
○
○
○
○
○
●
●
●
Publicidad
