Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING
Correct and regular maintenance of the battery will increases its lifespan. To achieve a long battery lifetime,
ƒ
keep its surface clean and dry.
If necessary, disconnect the clamps (negative terminal first) and clean the clamps and terminal and reconnect
ƒ
the clamps (positive terminal first).
Perform any other cleaning tasks according to the user's manual of the battery's manufacturer.
ƒ
INSPECTION
Check the battery status according to the user's manual of its manufacturer.
CHARGING
If the battery voltage falls below a certain threshold, it will not be possible to start up the mower or to even
light up the display on the panel and the mower's electronic system will not load up. If this happens, attempt
to recharge the battery. A flat battery needs to be recharged as soon as possible, otherwise its cells may be
irreparably damaged.
Prior to charging, read the user's manuals of the battery manufacturer and the charger manufacturer and
proceed according to their instructions.
Never charge the battery while the engine is running.
Regularly charge the battery also when the mower has not been used for an extended amount of time. The
battery must be fully charged prior to putting the mower into operation after an extended period of time.
REPLACING THE BATTERY
In the event that it is no longer possible to charge the battery, it is necessary to replace it with a new one. Always
use a battery of the same size and type.
The mower enables the connection and use of a 12 V battery with a higher capacity than that of the
supplied battery.
Loosen the bolts on the clamps and fastened them to the battery terminals (1) and (2).
ƒ
ATTENTION: First disconnect the negative cable (–) and then the positive cable (+).
Open the fastening clip (3) and remove the battery from its compartment.
ƒ
Attach and connect the new battery in reverse sequence to its connection and removal.
ƒ
ATTENTION: When connecting a new battery, it is always necessary to first connect the positive
cable (+). The location of the terminals may differ based on the battery's manufacturer, therefore
always first check which side the terminal is located on.
After replacing the battery, it is necessary to set the time again. Proceed as described in
PREPARING FOR OPERATION / SETTING THE TIME.
ENGINE
This chapter provides only basic engine maintenance instructions. Further details about inspections,
maintenance and replacement are included in a separate user's manual supplied by its manufacturer.
To ensure safe operation of the mower, regularly inspect the engine and its parts:
- whether it has any damaged or visibly worn out parts.
- whether material is ageing (cracks)
- correct adjustment and leak-tightness of all parts of the fuel system, such as fuel lines, fuel tank, fuel tank
cap and couplers.
If necessary, have any faulty parts professionally replaced at an authorised service centre.
146
4.2
Publicidad
