Installation; Assembly And Installation; Figure 3, Scope Of Supply - Kemper Clean Air Tower Instrucciones De Uso

5 Installation

CAUTION
Risk of serious injuries by bruising during transport of filtration
device components!
The structural components may overturn and fall down in case of
unprofessional installation.
− Never stay under the structural components which have not
been installed properly!
− Use suitable standardized means for climbing and take care of
safe posture.
Notice
The operator may charge with assembly of the filtration device only the
persons who are well familiarized with this activity.

5.1 Assembly and installation

The assembled CleanAirTower device consists of three separate segments supplied
on two pallets. The first pallet [A] contains the ventilator unit (pos. 1) including
protection against activation. There is, with a clamping ring (pos. 4), the suction part
(pos. 3) fixed. The other pallet [B] contains the filtration unit (pos. 2) with the other
clamping ring.
●
Serial No.: 1502206
Technical modifications without previous notification and errors reserved.
KEMPER CleanAirTower Instruction manual - EN
- 65 -

Figure 3, Scope of supply

Rev.: 1
Status as of: 05/2014