Maintenance / Care; Precautionary Measures Prior To Cleaning And Maintaining The Machine; Trouble Shooting And Fault Eradication; Cleaning The Machine - Nilfisk-Advance SD 400 Instrucciones De Utilizacion

SD 400 / SD 430 / SD 500 / SDP 430
2 _5

Maintenance / care

2 _5.1 Precautionary
cleaning and maintaining the machine
Prior to maintenance
operations, the
disconnected
disconnecting the mains plug. Accidents
due to electrical voltage and moving parts
may be avoided in this manner.
When maintaining
machine, when
resetting to a different function it must be
ensured that the machine cannot start
accidentally. It must also be protected
from rolling off or tilting and no parts may
be in a position that may cause them to
fall down or close by themselves.
If in doubt about any safety matters
consult the
authorised agency before putting the
machine into use.
2 _5.2

Trouble shooting and fault eradication

Fault
Maschine does not function
Machine runs in a jerky manner
Machine wobbles
Table 3
If the fault in the machine is not eradicated
after following the procedure according to
the above table,
customer service must be informed and
commissioned with the execution of the
necessary repair work.
18
measures prior to
and cleaning
machine must be
from the mains by
or servicing the
exchanging parts or
manufacturer or their
Cause
•
the main plug (2, picture 1) is not
correctly inserted
•
the unit socket (5, Picture 1) is
not correctly inserted
SDP 430 only:
•
the thermo-protection has cut the
motor off.
•
soiled pad (1, picture 2)
•
Pad unevenly worn
•
Pad not fastened in centre of pad
holder
•
Pad holder or brush not installed
correctly
the manufacturer's
2 _5.3

Cleaning the machine

Keep the bottom part of the machine in clean condition.
Clean or exchange brushes and floor pads.
2 _5.4

Pad care

After using, clean coarse soiling from the pads, which
can be used on both sides, and replace the pads within
good time in order to achieve good cleaning results.
2 _5.5

Daily examination

•
Check mains cable for damage.
2 _5.6

Annual maintenance

An electrically-driven machine must be checked
annually according to
international regulations
This examination should be carried out by
a service technician who has been trained
by the manufacturer!
Remedy
•
ensure correct seating
•
ensure correct seating
•
leave machine to cool down for 5 - 10
minutes approx.
•
beat pad out / if necessary, wash out
under water
•
insert new pad
•
remove pad from pad holder, fasten in
centre of pad holder
•
remove pad holder or brush and re-install
2 _5 Maintenance / care
VDE-702 or comparable