Chapter 2: Controls, Sockets And Indicators; Ultravision™ Generator - Front Panel View - alesi ULTRAVISION Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Chapter 2: Controls, Sockets and Indicators

This section describes all of the controls, sockets and indicators on the front and side panels of the Ultravision generator,
Ultravision battery recharging station and Ultravision Mains Converter.
Warning
Read all instructions before operating this equipment. Failure to do so may result in damage to the generator and/or injury to
the patient or operator.
Ultravision™ generator – Front panel view
1 – Power On/Off switch and indicator LED
2 – Patient return socket
3 – Ionwand socket
4 – Proximity indicator LEDs
5 – Battery level indicator
6 – Generator fault indicator LED
Warning
All third-party equipment used with Ultravision must be certified according to the relevant particular standards associat-
ed with IEC 60601. The user is responsible for verifying that any accessory equipment complies with the requirements of
IEC 60601.
Be Aware
Connect accessories to the proper socket type. Otherwise, the system will not function properly.
1 – Power On/Off Switch and indicator LED
The power switch that controls power to the generator is located in the lower-left corner of the front panel (see Front Panel
View, above). To switch the generator on, place the power switch in the ON position (l). The indicator light should illuminate
green.
Turn the generator power off by placing the power switch in the OFF position (O). The indicator light should no longer be lit.
2 – Patient return socket and proximity indicator LED
The solid or split plate patient return electrode or Ultravision Patient Return Adaptor is inserted into this socket in order to
establish the return path.
Be Aware
The Ultravision Patient Return Adaptor must be inserted the correct way up. Failure to do so may cause damage to the
connector or Socket.
3 – Ionwand socket
The Ionwand connector is inserted into the Ionwand socket. This delivers the power to the Ionwand and causes the electro-
static precipitation of the particulates.
11

Publicidad

Tabla de contenido
loading

Tabla de contenido