Descargar Imprimir esta página

Progress PHN 1110 Manual De Instrucciones página 10

Horno empotrado
Ocultar thumbs Ver también para PHN 1110:

Publicidad

Idiomas disponibles

Idiomas disponibles

10 progress
• Do not use abrasive cleaners.
• Dry the stainless steel parts and glass with
a soft cloth.
• If there are stubborn stains, use commer-
cially available cleaners for stainless steel
or warm vinegar.
The oven's enamel is extremely durable and
highly impermeable.
The action of hot fruit acids (from lemons,
plums or similar) can, however, leave perma-
nent, dull, rough marks on the surface of the
enamel.
However such marks in the brightly polished
surface of the enamel do not affect the op-
eration of the oven.
Clean the oven thoroughly after every use.
This is the easiest way to clean dirt off. It pre-
vents dirt being burnt on.
Cleaning materials
Before using any cleaning materials on your
oven, check that they are suitable and that
their use is recommended by the manufac-
turer
Cleaners that contain bleach should NEVER
be used as they may dull the surface finishes.
Harsh abrasives should also be avoided.
External cleaning
Regularly wipe over the control panel, oven
door and door seal using a soft cloth well
wrung out in warm water to which a little liq-
uid detergent has been added.
To prevent damaging or weakening the door
glass panels avoid the use of the following:
• Household detergents and bleaches
• Impregnated cleaning pads that are un-
suitable for non-stick saucepans
• Brillo/Ajax pads or steel wool pads
• Chemical oven pads or aerosols
• Rust removers
• Bath/Sink stain removers
Clean the outer and inner door glass using
warm soapy water.
Should the inner door glass become heavily
soiled it is recommended that a cleaning
product such as "Hob Brite" is used Do not
use paint scrapers to remove soilage.
Oven cavity
The enamelled oven floor is best cleaned
whilst the oven is still warm.
Wipe the oven with a soft cloth which is
washed out in warm soapy water after every
use. From time to time a more thorough
cleaning is required. Use a commercially
available oven cleaner for this.
Replacing the oven light
Important! Separate the appliance from
the power supply by switching off the
fuse.
If the oven bulb needs replacing, the new
bulb must have the following specifications:
– Electric power: 15W / 25W
– Electrical rating: 230 V (50 Hz)
– Heat resistance up to 300 °C
– Connection type: E14
These replacement bulbs can be purchased
from your dealer.
To change the oven light:
1. Before proceeding ensure the oven is
cool and is disconnected from the elec-
tricity supply.
2. Push in and turn the glass cover anti-
clockwise
3. Remove the faulty bulb and replace with
the new one.
4. Refit the glass cover and restore the elec-
trical supply.
The oven door
The oven door consists of two panes of
glass. The oven door can be disassembled
and the internal panes can be removed to
make cleaning easier.
Warning! Remove the oven door before
cleaning it. The oven door could abruptly
close if you try to remove the internal
panes of glass when the door is still
assembled.

Publicidad

loading