Sony CBK-3620XS Instrucciones De Funcionamiento página 24

Using the protection cap
The protection cap is used to protect the
built-in connector during storage and
transport.
1
Attach the protection cap to the
imager block adaptor.
Align and attach using the four hex
screws, and tighten using a hex wrench
(tightening torque of 1.4 N·m).
2
Attach the receiver to the
protection cap.
Align with the index marks on the sides
of the receiver, and attach using the
two hex screws, and tighten using a
hex wrench (tightening torque of
1.4 N·m).
Note
The protection cap is a dedicated accessory
for the CBK-3620XS. Do not use the
protection cap with the CBK-3610XS. Doing
so may damage the unit.
About the startup time
• When an 8K imager block is extended by
connecting the CBK-3620XS, the camera
startup time is about 20 seconds longer
than in the unextended state.
24
Attaching to the Camera
• When the CBK-3620XS is connected to
the camera for the first time, the initial
camera startup time may be longer.