Threading The Machine; Needle Threader - JUKI 3622 Manual De Instrucciones

z
c
v
b
n
z
c
z
q
x
e
c
x
x
b
n
w
r

Threading the Machine

Raise the take-up lever to its highest position by
turning the handwheel toward you.
Raise the presser foot.
Place a spool on the spool pin as shown, with
thread coming from back of the spool.
z Draw the thread into thread guide using both
hands.
x While holding the thread near spool, draw
thread down into the tension area and then
around the check spring holder.
c Firmly draw the thread up and through the
take–up lever from right to left.
v Then draw the thread down and slip it into the
lower thread guide.
v
b Draw the thread down and slip it into needle
bar thread guide on the left.
n Thread the needle eye from front to back.

Needle Threader

z Raise the needle to its highest position. Push
down the needle threader knob q as far as it
will go.
The hook comes out through the needle eye
from behind.
q Knob
x Paying close attention to the needle point,
draw the thread around the guide e and under
the hook w.
w Hook
e Guide
c Release the knob slowly while holding the
thread end r with your hand. A loop of the
thread is pulled up through the needle eye.
r Thread end
22