Publicidad
Idiomas disponibles
Idiomas disponibles
2. INSTALLING THE LRS-03
The LRS-03 must be installed by a qualified person or firm, according to existing regulations
(ministerial order no. 21712 issued by the Spanish Development Ministry, dated 26/10/1999
for Spain). If not, the guarantee is annulled and
the malfunction of the unit or for any damage directly or indirectly caused to other units
connected to the LRS-03. The LRS-03 is correctly installed by following these steps:
2.1 Connecting the LRS-03
In order for the LRS-03 to cover the entire sound chain, it must be inserted into the
reproduction chain between the mixing desk and the crossover (see diagram). The back
panel of the LRS-03 features symmetrical (XLR or Cannon connector) and non-symmetrical
(RCA connector) inputs and outputs.
It is vitally important to make sure that the electrical installation to which both the LRS-03 and
the equipment forming the reproduction chain are connected is earthed and complies with
low-tension regulations currently in force.
Mixing desk
2.2 Placing and connecting the sensor
The sensor is placed on the ceiling of the establishment at a point equidistant from the
speakers, using the drills provided. Once the sensor has been placed, it is connected to the
LRS-03 by the connecting cable also provided. Should you need a longer cable than the one
provided, get in touch with any official
connected to the LRS-03, the lid is screwed in place.
INPUT
CONNECTOR
2
1
Equalizer
3
1 – GND
2 – + SIGNAL
3 – - SIGNAL
22
will not be responsible for either
OUTPUT
CONNECTOR
1
2
Crossover
3
1 – GND
2 – + SIGNAL
3 – - SIGNAL
LRS-03
distributor. Once the sensor has been
Loudspeaker
s
Sensor
Publicidad
