Publicidad
conditions, leave completely open in
a warm place. Dry with a soft cloth.
Storage of a damp rocker will lead to
apperance of mould.
Do not leave the rocker in the boot of
a car.
Avoid exposure to water; exposure to
damp environments can encourage the
appearance of rust.
Clean the rocker's mechanisms fully
after exposure to sand and salt.
If one of the rocking mechanism's parts
becomes stiff or squeaks, or if you have
difficulty operating any of them, check
that dirt is not the cause of the problem.
Clean metal parts with a damp cloth
and a water-based solution.
REMOVABLE AND WASHABLE
TEXTILE.
When storing the rocker, never place
any objects on top as this could
damage the rocking mechanism.
Regularly check the most important
parts of the rocker: loose screws,
material
and
seams.
replace any damaged pieces.
USE OF THE MUSIC SYSTEM
To turn on the music system, push the
upper button with the musical note
symbol. 5 melodies will be played
simultaneously. To turn it off, just push
the same button again.
USE OF THE VIBRATION SYSTEM
To turn on the vibration mechanism,
push the lower button with the vibration
symbol. To turn it off, simply push the
same button again.
BATTERY USAGE AND
REPLACEMENT
Works with three batteries, "AA" (LR6)
not included.
The batteries should be fitted by an
adult.
Tool needed to fit the batteries: Philips
screwdriver (not included)
REPLACING THE BATTERIES
Attention: Batteries are not included
with the baby bouncer. We recommend
fitting
batteries(LR6).
• Find the battery compartment cover
at the lower part of the bouncer.
• Remove the screw from the battery
compartment cover with a Philips
screwdriver
• Remove the exhausted batteries and
dispose of them in a battery-recycling
container.
• Fit three "AA" alkaline batteries (LR6).
• Replace the battery compartment
cover, replace the screw and tighten
with a Philips screwdriver, do not over
Immediately
tighten.
• If the baby bouncer stops working
correctly,
batteries.
BATTERY SAFETY
Under
batteries may leak corrosive liquid
that can cause burns or damage the
product. To avoid leakage of corrosive
liquid:
• Do not mix new and exhausted
batteries or batteries of different types.
• Fit the batteries as indicated in the
battery compartment
• Remove the batteries from the
product if it is not going to be used
three
new
"AA"
replace
the
exceptional
circumstances
alkaline
exhausted
Publicidad
