Eurocave V-ROYALE-L Modo De Empleo página 15

5/ LAYOUT – STORAGE
a.
b.
d.
Slide the shelf until the rear hooks of the shelf are locked into the
slots provided in the runners.
f.
2
1
N.B. : in order to prevent the shelf from tipping over, ensure that the studs on each side of the shelf are pushed all the way
14
EN into the holes, before pulling out the shelf.
1
1
2
2
c.
1
TAC !
2
Position your shelf along the left and right runners and start by
securing the rear section of the shelf.
e.
Then slot the front studs of the shelf into the slots provided in the
front section of the runners. You must jiggle the shelf in order to slot
the studs into the holes. Start by inserting the left stud. The right one
will then slot naturally into the oblong hole.
g.
2
1
5/ LAYOUT – STORAGE
Please note: To configure your cabinet to store magnums (see p.117), place the runners in the notches marked with
the shape opposite.
II. Assembling and using the shelf labels
The epoxy-coated steel shelf labels allow you to identify your bottles and find them
easily. White marker pen supplied in the "accessories" box (erasable).
c.
b.
III. Assembling the supports and Main du Sommelier bottle supports
x12
6/ USING YOUR WINE CABINET FOR THE FIRST TIME
1. Connecting and starting up
After waiting 48 hours, plug in your wine cabinet.
To switch on, press and hold down the button for 5 seconds.
II. Description
The tactile keys are very sensitive. There is no need to apply force, a light touch is sufficient to register the command. Remember to remove your finger
from the control between each press.
A B C D
N
A
Lighting mode adjustmentbutton (3 modes)
B
Open door indicator
C
Warning light
D Temperature alarm
E
Compressor status light
F
Heater status light
G Charcoal filter alarm
x8
Have your socket checked (presence of correct sized fuses and
30 mA circuit breaker). Do not plug several cabinets into a multi-
socket adaptor.
E F G H I J K L
+
set
M
H
High humidity level alarm (if flashing)
I
Low humidity level alarm
(filling humidity tray)
J
Confirmation and settings access key
K Setting and selection keys
L
On/off/standby key
M
Relative humidity level display (cannot be set)
N Temperature display (cannot be set)
15
EN