Starting / Stopping The Engine - Stihl FS 310 Manual De Instrucciones

Ocultar thumbs Ver también para FS 310:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Starting / Stopping the
Engine
Controls
STOP-
START
4
5
6
3
7
2
1
Throttle trigger lockout
2
Throttle trigger
3
Slide control
Positions of slide control
4
STOP-0 – engine off – the ignition is
switched off
5
F – normal run position – the engine
is running or can start
6
START – ignition is switched on –
the engine can start
Symbol on slide control
7
h – stop symbol and arrow. To stop
the engine, push the slide control in
the direction of the arrow on the stop
symbol (h) to STOP-0.
FS 310
Starting
Press down the trigger lockout lever
N
and squeeze the throttle trigger
and hold them in that position.
N
Move the slide control to START
N
and hold it there.
Now release the throttle trigger,
N
slide control and trigger interlock in
that order. This is the starting
throttle position.
1
Set the choke knob (8):
N
g if the engine is cold
e for warm start – also use this posi-
tion if the engine has been running
but is still cold.
Press the manual fuel pump
N
bulb (9) at least five times – even if
the bulb is already filled with fuel.
9
8
Put the unit on the ground: It must
N
rest on the engine support and
deflector. Check that the cutting
attachment is not touching the
ground or any other obstacles.
Make sure you have a firm footing.
N
Hold the unit with your left hand and
N
press it down firmly – your thumb
should be under the fan housing.
NOTICE
Do not stand or kneel on the drive tube
since it will otherwise be permanently
bent and damaged.
English
29

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido