Mounting The Bike Handle - Stihl FS 310 Manual De Instrucciones

Mounting the Bike Handle

3
1
Hold the lower clamp (1) steady.
N
Unscrew and remove the clamping
N
screw (2). The clamps are loose
once the clamping screw has been
removed.
Remove the upper clamp (3) from
N
the lower clamp.
FS 310
2
Place the handlebar (4) in the lower
N
clamp (1) so that distance A is no
more than 6 in (15 cm).
Place the upper clamp in position
N
and press it down.
Insert the clamping screw.
N
Line up the handlebar at a right
N
angle to the drive tube.
Tighten down the clamping screw
N
firmly.
A
4
1
8
7
5
6
Take out the screw (5), the nut (6)
N
remains in the control handle (7).
Push the control handle onto the
N
end of the handlebar (4) until the
holes (9) line up – the throttle
trigger (8) must point towards the
gearbox.
Insert the screw and tighten it down
N
firmly.
Go to "Adjusting the Throttle Cable".
N
Transport and storage position: Loosen
the clamping screw, turn the handlebar
in line with the drive tube and fold the
handles down.
English
7
9
4
9
19