English
Swing wire rod into position.
N
Hook wire rod to the transport
N
guard.
Universal Transport Guard
1.
2.
Disconnect wire rod from the
N
transport guard and swing it
outwards.
32
2.
Fit the transport guard on the cutting
N
attachment from below.
Attach wire rod to the hook on the
N
transport guard.
Operating Instructions
During break-in period
2.
A factory-new machine should not be
run at high revs (full throttle off load) for
the first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
During Operation
After a long period of full throttle
operation, allow the engine to run for a
short while at idle speed so that engine
heat can be dissipated by the flow of
cooling air. This protects engine-
mounted components (ignition,
carburetor) from thermal overload.
After Finishing Work
Storing for a short period: Wait for the
engine to cool down. Empty the fuel tank
and keep the machine in a dry place,
well away from sources of ignition, until
you need it again. For longer out-of-
service periods – see "Storing the
Machine".
FS 310