Mounting The Cutting Attachment - Stihl FS 310 Manual De Instrucciones

6
5
Remove dirt from joints on gearbox
N
and deflector – make sure that no
dirt gets into the screw holes in the
gearbox.
Place the deflector on the
N
gearbox (5).
Insert the screws (6) and tighten
N
them down firmly.
FS 310
Mounting the Cutting
Attachment
Placing power tool on the ground
Shut off the engine.
N
Lay your power tool on its back so
N
that the cutting attachment
mounting face is pointing up.
Mounting Hardware
The mounting hardware supplied
depends on the cutting attachment that
comes as original equipment with the
new machine.
The mounting hardware is fitted to the
gearbox for transportation and must be
removed before mounting a cutting
attachment.
Removing the Mounting Hardware
1
2
3
4
Block the shaft.
N
Use the combination wrench (1) to
N
loosen and remove the nut (2)
clockwise.
Remove the rider plate (3) and
N
thrust washer (4) (where fitted).
Checking the Thrust Plate
The thrust plate is necessary for
mounting all cutting attachments to the
gearbox.
English
21