Publicidad
Idiomas disponibles
Idiomas disponibles
Rods and cylinders
36 Install o-rings (22) onto each end of
extension cylinder (23).
NOTE
Make sure o-ring (22) fits in groove at
shoulder of extension cylinder (23)
(† Fig. 5, page 19).
NOTE
If a primer is used with threadlocker,
curing time is reduced.
37 Screw extension cylinder (knurled end
first) with threadlocker into body
assembly.
NOTE
Do not tighten at this time.
38 Install bung adapter (21) onto extension
cylinder.
39 Screw coupling (24) onto extension cyl-
inder (with threadlocker).
NOTE
Do not tighten at this time.
Valve seat and guide assembly
40 Install valve seat and guide assembly
onto extension rod (25) until spring clip
holes align.
41 Install spring clip (2).
NOTE
Make sure o-ring (34) fits in groove at
shoulder of cylinder (35) († Fig. 5,
page 19).
42 Install o-rings (34) onto each end of cyl-
inder (35).
CAUTION
Use care installing cylinder (35) into
coupling (24). Damage to
V-packings (16) can occur.
43 Screw cylinder (knurled end first) with
threadlocker into coupling.
NOTE
Do not tighten at this time.
16
Valve body
44 Install ball (38) into top of valve
body (39).
45 Install and seat washer (37) and stop
washer (36) convex upward into
valve body.
46 Screw valve body assembly onto cylinder
(with threadlocker). Make sure ball
moves freely.
47 Place a large wrench or other suitable
tool into slot of valve body. Tighten all
components of assembly securely.
48 Install tag (10) and hydraulic fitting (9)
as required.
49 Screw valve seat (12) with screw (13) into
body as required. Make sure bleed hole
points downward.
Publicidad
