YASKAWA LA500 Manual De Instrucciones página 24

1 English
No.
Name
(Hex.)
b1-14 Phase Order Selection
(01C3)
C1-01 Acceleration Time 1
RUN
C1-02 Deceleration Time 1
RUN
C2-01 S-Curve Time @ Start
of Accel
C2-02 S-Curve Time @ End
of Accel
C2-03 S-Curve Time @ Start
of Decel
C2-04 S-Curve Time @ End
of Decel
C2-05 Jerk below Leveling
Speed
C3-01 Slip Compensation
Gain
(020F)
RUN
Expert
C3-02 Slip Compensation
Delay Time
(0210)
RUN
Expert
C6-02 Carrier Frequency
Selection
d1-01 - d1-08 Reference 1 to 8
RUN
d1-18 Spd Ref Sel Mode
(02C0)
d1-19 Nominal Speed
(02C1)
RUN
d1-20 Intermed Speed 1
(02C2)
RUN
d1-21 Intermed Speed 2
(02C3)
RUN
24
Sets the phase order for output terminals U/T1, V/T2, and W/T3. This parameter
can align the Forward Run command from the drive and the forward direction of
the motor without changing wiring.
0: Standard, 1: Switch Phase Order
Sets the length of time to accelerate from zero to maximum output frequency.
Sets the length of time to decelerate from maximum output frequency to zero.
Sets the S-curve acceleration time at start.
Sets the S-curve acceleration time at completion.
Sets the S-curve deceleration time at start.
Sets the S-curve deceleration time at completion.
Sets the S-curve time used when the speed reference is lower than the Leveling
speed setting.
Sets the gain for the slip compensation function. Usually it is not necessary to
change this setting.
Sets the slip compensation delay time when speed is unstable or when the slip
compensation response is too slow. Usually it is not necessary to change this
setting.
Sets the carrier frequency for the transistors in the drive.
1: 2.0 kHz, 2: 5.0 kHz (4.0 kHz for AOLV/PM), 3: 8.0 kHz, 4: 10.0 kHz,
5: 12.5 kHz, 6: 15.0 kHz
Sets the frequency reference.
Sets the priority of the speed reference digital inputs.
0: Use Multi-Speed references d1-01 to d1-08,
1: High speed reference has priority, 2: Leveling speed reference has priority
Sets the speed reference when multi-function input "Nominal Speed" is on.
Sets the speed reference when intermediate speed 1 is selected by digital inputs.
Sets the speed reference when intermediate speed 2 is selected by digital inputs.
YASKAWA TOMPYEULA5001C LA500 Installation and Operation Instructions
Description