Publicidad
Idiomas disponibles
Idiomas disponibles
12. Install the Second Wall Panel
Back Side
NOTE: Use silicone adhesive if the wall panels are being installed over tile. For all other applications, use the adhesive
type specified in the instructions included with the shower walls.
Apply adhesive to the back wall panel in a circular pattern. The beads of adhesive should be 5" (127 mm) to 7" (178
mm) apart.
Apply a bead of adhesive along the top edge of the wall panel 3/4" (19 mm) from the edge.
Move the wall panel into place at a slight angle with the corner joint, if installed, fully pressed into the corner.
Push the wall panel against the rough wall. Press firmly and evenly across the entire wall panel. The wall panel should
contact the rough wall along the entire area.
Push the panel against the rough wall and into the installed seam joint. Press firmly and evenly across the entire wall.
The panel should contact the rough wall along the entire area.
Confirm the locker unit contacts the seam joints along the entire area.
Remove excess adhesive with your finger.
NOTE: Bracing may be needed to hold the wall panel in place depending on the rough wall material and adhesive being
used.
When installed over tile, use a temporary brace to secure each wall panel in place for 48 hours to allow full adhesion.
1484881-2-A
Corner Joint (optional)
Corner Joint
16
Kohler Co.
Publicidad
