Kohler K-97630 Instrucciones De Instalación página 8

4. Trim the Locker and Walls
Sanding Block
Cut Wall Placement
IMPORTANT! The cut edge of the panel MUST be positioned opposite the seam. The vertical edge of the seam MUST
mate to an uncut, bevel molded edge on the panel.
NOTE: A seam joint can be used between panels but the trimmed edge location requirements remain unchanged.
Cutting the Walls and Locker
IMPORTANT! Follow the cutting instructions provided with the wall panels.
IMPORTANT! Do not cut the sides of the locker unit. Only trim the top or bottom to fit your wall length.
IMPORTANT! The locker unit must be placed with the shelf grooves angled upward. If the locker unit is placed upside
down the shelves will fall out.
Position the back wall panel face down on a stand or sawhorses that have a protective material on them.
Cut the back wall panel to the required dimensions.
Repeat for the side wall panels.
NOTE: Remove any protective films on the locker unit surface before cutting.
Cut the locker unit to the required height dimensions using a fine toothed blade.
From the front side of the panel, use a hole saw to cut the holes for valving and other shower components.
IMPORTANT! It is critical the wall panels and locker unit are clean for a strong bond to be created by the adhesive.
On the edges of each panel, remove excess material and smooth any rough edges using a sanding block.
Clean the back of the wall panels and locker unit with denatured alcohol.
1484881-2-A
Back Side
Cut Edge
Uncut Edge
Shower Valving
8
Side Wall Panel
Kohler Co.