Publicidad
Idiomas disponibles
Idiomas disponibles
2. Measure Components
Seam Joint
Determine if there will be vertical or horizontal seams beyond the corner locations. Order optional seam joints as
needed.
Determine if edge trim will be installed. Order optional edge trim as needed.
Measure the installation area to determine the cut dimensions for the panel(s).
Back Wall Measurement
Subtract 1/16" (2 mm) from the width of each back wall panel for the locker unit seam joints.
Subtract 1/16" (2 mm) from the wall panel's height or width for each additional seam joint.
Subtract half the total width of the locker unit from the width of each back wall panel.
If corner joints will be installed, subtract 1/16" (2 mm) from the width of the back panels for each corner joint.
Mark the cut-lines on the back side of the back panel.
Side Wall Measurement
If corner joints will be installed, subtract 5/16" (8 mm) from the width of each side wall panel before cutting.
Subtract 1/16" (2 mm) from each panel's height or width for each seam joint that will be installed.
Record the location of the handle, showerhead, bath spout, and other components.
Mark the cut-lines on the back side of the side wall panels.
1484881-2-A
6
Kohler Co.
Publicidad
