cecotec DRUMFIT X-BIKE 3000 NEO PRO Manual De Instrucciones página 28

ENGLISH
Workout routine
To maintain or improve your physical condition, exercise three times per week, with at least
one day of rest between workouts. After a few months of regular exercise, you may exercise
up to five times a week, if desired. Keep in mind that the key to success is making exercise a
regular and enjoyable part of your everyday life.
6. TROUBLESHOOTING
Check that all bolts and nuts are tight and that the rotating parts rotate freely.
1.
2. Clean the appliance only with soap and a slightly damp cloth. Do not use solvents to clean
the appliance.
Problem Cause
The ground is not flat or there is an
1.
The base is object under the stabiliser.
unstable 2. The rear stabiliser end caps have not
levelled out when adjusted.
The handlebar is The bolts are loose.
not stable
Loud noise from The parts are not tightened properly.
moving parts
Little resistance Low resistance intensity.
1.
2. The resistance knob is damaged.
3. The bearings are damaged.
7. CLEANING AND MAINTENANCE
Note
The frequency of cleaning and maintenance indicated is a guideline. It will depend on the
frequency and intensity of the user.
- Examine the equipment periodically in order to detect any issue, such as loose bolts.
- Lubricate the moving parts periodically to prevent premature wear.
- Inspect and tighten all parts before using the machine. Replace any defective parts
immediately, and do not use the machine again until it is in perfect working condition.
54 DRUMFIT X-BIKE 3000 NEO PRO
Solution
Remove the object.
1.
2. Tighten the rear
stabiliser end caps.
Tighten the bolts.
Tighten them.
Open the lid.
1.
2. Change the
resistance knob.
3. Change the
bearings.
- The machine can be cleaned using a slightly damp cloth and mild non-abrasive detergent.
Do not use solvents.
- Do not try to repair the machine by yourself. Should you have any difficulty with the
assembly or operation of the exercise bike, or if you think that any part is missing, contact
the official Cecotec Technical Support Service.
- You must check the screw condition every two or three weeks.
- If cranks get loose:
Remove the trim.
1.
2. Reinforce lightly with a ring spanner.
3. Place the trim back on.
- Once a month, apply oil in the interior part of the pedals.
- After lubricating some of the moving parts, run the exercise bike normally for at least half
a minute.
- You can clean the rest of parts with a slightly damp cloth.
- Storage (Fig. 12):
Remove the spring pin from the main frame.
1.
2. Store the bicycle in a folded state.
3. Re-insert the spring pin into the main frame.
- Storage of the twisting disc (Fig. 13):
1. Remove the spring pin from the rear stabiliser.
2. Store the twisting disc in folded state.
3. Reinsert the spring pin back into the rear stabiliser.
8. TECHNICAL SPECIFICATIONS
Product reference: 07176
Product: DrumFit X-Bike 3000 Neo Pro
Maximum user weight: 100 kg
HC Class
Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain
9. DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES
This symbol indicates that, according to the applicable regulations, the
product and/or batteries must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should
ENGLISH
DRUMFIT X-BIKE 3000 NEO PRO 55