HURNER CNC ECO 1000 2.0 Manual De Instrucciones página 51

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
For the input of data, an alphanumeric keypad is
provided. It is designed and works like the keypad of
a common mobile phone without touch screen dis-
Info
play. All characters found on a key can be "browsed"
by pressing that key repeatedly at short intervals. As
soon as "browsing" generates the desired character
on the screen, wait a little longer until you press
the next key to use the displayed character. The first
character always is the number on the respective
key, then the letters or marks in the order on the
key, i. e., for instance, with the key "2 | a | b | c" the
1st keypress brings up "2," the 2nd "a," the 3rd "b,"
and the 4th brings up "c." By default, lower-case
letters appear on the screen. To enter upper-case
letters, hold down the ñ key while selecting the ap-
propriate letter by one or several keypresses.
4.2.1 Entering the Welder ID Code
When the welding is started by pressing the START/SET key
while Display 3 is showing, first the input of the welder
identification code is requested, if it is enabled in the con-
figuration menu (see Display 11). The code has to be an ISO-
compliant code. It can be entered either using the alphanu-
meric keypad (refer to the Info at the beginning of Sect. 4.2)
and confirming the input by pressing the START/SET key, or
by reading a RFID transponder card or scanning it from a bar
code with the optional handheld scanner.
When the code was properly scanned or entered, this is con-
firmed by an audible signal.
4.2.2 Entering or Changing the Commission Number
From Display 3 or after the welder identification code was
entered, the machine requests the input of the job num-
ber, or commission number, of a maximum 32 characters, if
it was enabled in the configuration menu. If a commission
number exists already in memory, this one is proposed. You
can either confirm it by pressing START/SET or change it us-
ing the alphanumeric keypad (refer to the Info at the begin-
ning of Sect. 4.2) or reading it with the scanner or from a
RFID card and then confirm the new number by pressing the
START/SET key.
It is possible to select a previously saved commission number
instead of the one shown on the screen by pressing the ï
and ð cursor keys simultaneously. This causes a screen to
show in which you can scroll through the commission num-
bers in memory using the ï and ð keys, to select a number
and then confirm it by the START/SET key. This number will
be used for the next welding. To quit the scroll mode with-
out selecting a commission, press the STOP/RESET key.
Version October 2021 HÜRNER CNC ECO 1000 2.0 User's Manual
Enter Welder Code
++++++++++++++++++++
++++++++++
Display 11
Enter Commission No.
++++++++++++++++++++
++++++++++++
Display 12
EN
19