HURNER CNC ECO 1000 2.0 Manual De Instrucciones página 63

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
USB A Interface Port
for connecting USB mass storage media (such as a mem-
ory stick)
complying with the USB version 2.0 specification (i.e.,
maximum data rate of 480 megabits per second)
The information below in this section is relevant on-
ly for data transfer through the USB interface port.
Data download to a smartphone via Bluetooth is
Info
managed entirely in the HÜRNER Weld Trace app.
5.1 Selecting the File Format
Before transferring data, it is highly recommended
to switch the welding system off and on again. Ne-
glecting to do so creates a risk of data transfer fail-
Important
ure, or reports in the welding systen may get cor-
rupted.
When transferring welding reports to a USB stick,
always be sure to wait until the display shows the
"Download finished" message before you discon-
Important
nect the USB stick from the product. If you discon-
nect it too early, the system may ask you whether
you want to delete the reports in memory, although
they were not properly transferred. In this case,
if you delete the contents of the report memory,
the welding reports would be irrevocably lost and
would not be available elsewhere either.
Connecting the storage media causes a screen to appear in
which the format of the output file with the welding re-
ports can be selected: a PDF file with an abstracted or ex-
tended version of the report or the format of the welding
data management application DataWork. Using the ñ and ò
arrow keys, select the file type you need and confirm your
selection by pressing the START/SET key.
The CSV format enables import of the report data into a da-
tabase or spreadsheet application, provided this application
can read the format; this is the case, e.g., with Microsoft Ex-
cel.
The Service Report option is not important for normal op-
eration. In the scope of computer-assisted service, this re-
port lists events related to the maintenance of the welding
system.
5.2 Downloading All Reports
After the file type was selected, the next screen offers a
"Print All Reports" option. Selecting it will download all
Version October 2021 HÜRNER CNC ECO 1000 2.0 User's Manual
* Select File Type *
DataWork File
>PDF Abstract
PDF Ext'd Report
Display 34
EN
31