HURNER CNC ECO 1000 2.0 Manual De Instrucciones página 64

welding reports currently in system memory in the previ-
ously selected file format.
5.3 Downloading by Commission Number, Date or Report Range
After the file type was selected, the next screen offers a "By
Commission Number," a "By Date Range," and a "By Report
Range" options. Depending on the selection, the ñ and ò
arrow keys can be used to select from the commissions cur-
rently in system memory the desired one, of which the re-
ports should be downloaded, or the alphanumeric keypad
can be used (refer to the Info at the beginning of Sect. 4.2)
to enter a start date and an end date, or the first and the
last report, that define a range of dates or a range of re-
ports of which the reports should be downloaded. When
you press the START/SET key, you cause the selected reports
to be transferred to the storage media.
5.4 Understanding the Report Download Process
The download starts automatically after a selection was
made among the options. Wait for all the selected reports
to transfer and the "Download completed" message to ap-
pear on the screen.
If a problem occurs while the download is in progress, a
"Not ready" message shows. After the problem condition is
cleared, the download resumes automatically.
If the welding unit recognizes a problem that can-
not be cleared while the data transfer is in prog-
ress, it does not resume the process and displays a
Info
"Download cancelled" error message. To acknowl-
edge this error, press the START/SET key.
5.5 Deleting Data from Memory
The report data in memory can be deleted only after all
welding reports were transferred, which is indicated by the
"Download completed" message. When the storage media
is unplugged, a "Delete Memory" message appears. If the
START/SET key is pressed at this point, a further confirma-
tion message "Delete Memory, sure?" is shown, which has
to be confirmed once again by pressing the START/SET key.
Then, the report data in memory are deleted.
5.6 Keeping Data in Memory
When the cable or storage media is unplugged, a "Delete
Memory" message is displayed. Press the STOP/RESET key to
keep the current report data in memory. The process can
then be repeated once again.
32
EN
HÜRNER CNC ECO 1000 2.0 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Version October 2021