Bosch GTS1041A Instrucciones De Funcionamiento página 11

27. NEAR FIELD COMMUNICATION
INTERFACE
Target to place a smart phone with the Bosch
power tools app next to this surface to get a sta-
tus report about the saw
28. DROP ARM
Moves the blade down and away from the opera-
tor after contact between the user and the blade
is detected.
29. ACTIVATION CARTRIDGE
Contains two single shot cylinders each of which
can independently force drop arm to drop below
table surface away from the user. Only one of the
two single shot cylinders is active during opera-
tion.
30. LATCH
Ensures the drop arm is held in the proper po-
sition for operation. The latch also prevents the
arm returning to the closed position until a new
Activation Cartridge is properly installed
31. DROP ARM LOCK
Ensures the drop arm stays underneath the table
after activation. Release for reset to operating
position.
Fig. 2d
1600A009XC 09-15.indb 11
35
37
36 33 29
32. DETECTION PLATE
Allows the Active Response Technology™ to
measure the blade for signs of user contact with
the saw blade.
33. ACTIVATION CARTRIDGE RETAINER
Holds the Activation Cartridge in place during
operation and activation. It must be installed
properly to latch the drop arm in the operating
position.
34. SIDE STORAGE COMPARTMENT
Holds spare activation cartridges, quick reset in-
structions, and the manual.
35. RIVING KNIFE OR SPREADER
A device that keeps the kerf of the work piece
open as the material is cut. This minimizes the
potential of the work piece binding against the
saw blade. It is stored under table when not in
use.
36. CARTRIDGE PLUG
Electrical connection that links the saw electron-
ics to the activation cartridge.
37. RIVING KNIFE RELEASE LEVER
Lever that allows for adjustments
28
11
22
31
9/14/15 1:51 PM