Bevel Ripping - Bosch GTS1041A Instrucciones De Funcionamiento

B. Riving knife is properly aligned with saw blade.
C. Anti-kickback pawls are functioning properly.
Position wider portion of the workpiece on side
of the fence.
When ripping LONG BOARDS or LARGE PAN-
ELS, always use a work support. The Bosch table
saw outfeed support table kit (TS1016) is an ideal
accessory to use for this application. A simple
work support can be made by clamping a piece
of plywood to a saw horse (Fig. 59).
Fig. 59

BEVEL RIPPING

When bevel ripping material 6" or narrower, use
fence on the right side of the blade ONLY. This
will provide more space between the fence and
the saw blade for use of a Push Stick. If the fence
is mounted to the left, the saw blade guard may
interfere with proper use of a Push Stick.
When "WIDTH OF RIP" is 6" and WIDER use
your RIGHT hand to feed the work piece, use
LEFT hand ONLY to guide the work piece. Do not
FEED the work piece with the left hand (Fig. 60).
When "WIDTH OF RIP" is 2" to 6" wide USE THE
PUSH STICK 1 to feed the work piece (Fig. 61).
When WIDTH OF RIP is NARROWER than 2" the
Push Stick CANNOT be used because the guard
will interfere, USE the AUXILIARY FENCE, and
PUSH BLOCK.
Attach auxiliary fence 2 to rip fence with two "C"
clamps (Fig. 62).
Feed the work piece by hand until the end is ap-
prox. 1" from the front edge of the table. Continue to
feed using the PUSH BLOCK 3 on top of auxiliary
fence UNTIL THE CUT IS COMPLETE (Fig. 63).
NON THROUGH-CUTTING
Add 8" high flat facing board to the fence, the full
length of the fence (Fig. 64).
Use featherboards for all "Non Through-cutting"
1600A009XC 09-15.indb 36
Fig. 60
2-6"
Fig. 62
operations (when saw blade guard must be re-
moved).
Featherboards 1 are used to keep the work in
contact with the fence and table as shown, and to
stop kickbacks. Mount featherboards 1 to fence
and table as shown, so that leading edges of
feather-boards will support work piece until cut is
complete, and the work piece has been pushed
completely past the cutter (saw blade, dado head,
etc.) with a Push Stick 2, as in ripping. Before
starting the operation (switch saw "OFF" and set
cutter below table surface):
36
Fig. 61
1
2
9/14/15 1:51 PM