Bosch GTS1041A Instrucciones De Funcionamiento página 47

Problem
Cannot reset drop arm
Excessive vibration
Cannot make square cut
when crosscutting
Cut binds, burns, stalls motor
when ripping
Cut not true at 90° or 45°
positions
Tilt lock handle elevation
wheel hard to move
Board catches at front or rear
of table insert
1600A009XC 09-15.indb 47
Cause
Activation cartridge
not installed or not
installed correctly.
Activation cartridge
retainer not tight.
Used Activation
Cartridge is installed.
Failure to tighten tilt
lock handle.
Blade out of balance.
Saw not mounted
securely to stand or
workbench.
Arbor Nut not tight.
Miter Gauge not ad-
justed properly.
Dull blade with im-
proper tooth set.
Warped board.
Rip fence not parallel
to blade.
Riving knife out of
alignment.
Alignment screws not
adjusted properly
Blade tilt lock handle
not loosened when
making tilt adjustment.
Saw dust on elevation
support rods.
Table insert not ad-
justed properly
47
Corrective Action
Ensure that activation cartridge is
installed correctly (see page 13).
Tighten the activation cartridge
retainer according to instructions
on page 14.
Install per the Reset instructions on
page 13.
See "Blade Bevel Control " section,
page 28.
Discard blade and use different
blade.
Tighten all mounting hardware, See
"Mounting the Table Saw" section,
page 18.
See "Assembly" section, "Changing
The Blade" , page 17.
See section, "Miter Gauge Adjust-
ment" , page 20.
Sharpen or replace blade.
Make sure concave or hollow side
is facing "DOWN" , feed slowly.
See section "Aligning Rip Fence" ,
page 21.
See "Checking Riving Knife Align-
ment" section, page 23.
See section, "Adjusting Blade Paral-
lel to Miter Gauge Slots" , page 20.
See "Blade Bevel Control " section,
page 28.
See "Maintaining Your Table Saw"
section, "Lubrication" , page 42.
Adjust table insert per instructions
on page 22.
9/14/15 1:51 PM