Positioning The Riving Knife; Attaching The Guard Assembly - Bosch GTS1041A Instrucciones De Funcionamiento

ATTACHING THE
SMART GUARD SYSTEM
To prevent personal injury,
always
from power source before attaching or remov-
ing the Smart Guard System.

POSITIONING THE RIVING KNIFE

1. Remove table insert using table insert lock.
2. Raise the blade as high as it will go and set it
perpendicular to table (0° on bevel scale) (Fig.
10).
3. Rotate the riving knife release lever 1 clock-
wise, so that it points upward (Fig. 10).
4. Pull riving knife 2 towards release lever to dis-
engage it from the pins 3 (Fig. 11).
5. Slide the riving knife 2 up to its highest posi-
tion, so that it is directly over the center of the
blade (Fig. 11).
6. Align holes in riving knife with pins 3 and lock
the release lever 1 by rotating it counter-clock-
wise. Push/pull riving knife to verify that it is
locked in place (Fig. 11).
7. Replace table insert and lock.
ATTACHING THE
GUARD ASSEMBLY
8. With one hand, hold the front of the barrier
guard assembly 4 by the metal "fork" . With the
other hand, hold the guard release lever 5 up
(Fig. 12).
9. Lower the rear of guard assembly and slip the
cross bar 6 into the rear notch 7 on top of the
riving knife 2 (Fig. 12).
1600A009XC 09-15.indb 15
Fig. 10
disconnect plug
Fig. 12
4
5
15
Fig. 11
2
2
1
3
2
1
7
6
9/14/15 1:51 PM