Getting To Know Your Table Saw - Bosch GTS1041A Instrucciones De Funcionamiento

1. POWER SWITCH
Switch for turning motor on and off. Switch in-
corporates a hole for use with padlock to prevent
accidental starting.
2. TABLE
Provides large working surface to support work
piece.
3. BASE / SUB-BASE
Supports table saw. Sub-base provides additional
stability and ability for easy sliding onto surfaces.
Holes are provided in base to bolt the saw to a
workbench or stand.
4. BLADE BEVEL LOCK HANDLE
Locks the blade to desired bevel angle.
5. TABLE EXTENSION
Provides a larger work surface for wider work
pieces.
6. TABLE EXTENSION LOCK HANDLE
Allows you to lock the table extension at desired
distances.
7. ELEVATION WHEEL
Elevates or lowers the blade. Also used to tilt the
blade 0 to 45 degrees.
8. BLADE BEVEL SCALE
Shows the degree the blade is tilted.
9. RIP FENCE SCALE
Shows the distance from the blade to rip fence
through a convenient viewing and magnifying
window. Lower portion of scale can be used up to
12.75 inches. Upper portion of scale is used for
cuts beyond 12.75 inches.
Fig. 1
13
1600A009XC 09-15.indb 9

Getting To Know your Table Saw

19
10 21 35
2
26 27 25
1
10. MITER GAUGE
Head can be locked in desired position for cross-
cutting or mitering by tightening the lock knob.
ALWAYS SECURELY LOCK IT WHEN IN USE.
11. RIP FENCE STORAGE
Conveniently stores rip fence on bottom of table
when not in use.
12. PRE-CUT (KERF) INDICATOR
Allows you to mark and locate exactly where the
blade will enter the work piece.
13. MITER GAUGE STORAGE
Conveniently stores miter gauge when not in use.
14. BLADE STORAGE & WRENCH
Allows you to store 10" blades, blade wrench
and activation cartridge installation tool. Blade
wrench also has a 10mm hex hole allowing as-
sembly of the Gravity-Rise stand and for use with
dado clamp bolt.
15. HEX WRENCH / PHILLIPS SCREWDRIVER
Hex wrench for adjusting various hex head bolts
on saw. Phillips screwdriver is for assembling the
saw to a Gravity-Rise stand.
16. CORD WRAP
Allows you to easily secure the cord so it's out of
the way when transporting or storing.
17. VACUUM HOOK-UP
Your table saw is equipped for vacuum hook-up.
This feature will allow you to attach any 2-1/4"
vacuum hose into the dust port provided for con-
venient saw-dust removal. An adaptor is available
for use with alternate hose sizes.
12 18 9
7 4 8
9
5
11
6
24
3 23
9/14/15 1:51 PM