Troubleshooting; Corrective Action - Bosch GTS1041A Instrucciones De Funcionamiento

Problem
No information panel lights
are on, or saw will not turn on
Green light on
Note: When the saw is initially plugged in, Information Panel flashes Blue, then Solid Yellow
and then Solid Green. This is the normal sequence of the Information Panel LEDs when the
saw is plugged in.
Saw will not start
Yellow light on when switch
turned on
Saw is plugged in and Red
light begins to flash immedi-
ately
Saw will not start and Red light
is flashing
1600A009XC 09-15.indb 44

Troubleshooting

Cause
Power cord not
plugged in.
Fuse or circuit breaker
tripped.
Cord damaged.
Saw is plugged in.
Burned out switch.
System is in bypass
mode.
Power switch is in the
"ON" position when
saw is plugged in.
Bypass switch stuck in
"ON" Position.
Activation Cartridge
is not connected cor-
rectly.
Burned out power
switch
44

Corrective Action

Plug saw in.
Replace house fuse or reset
tripped breaker.
Have cord replaced by Authorized
Bosch Service Center.
No action needed, Green light
indicates that the saw is operating
as intended.
Have switch replaced by an Autho-
rized Bosch Service Center.
No action needed. Yellow Light
indicates that the saw operating as
intended in bypass mode. Bypass
mode is explained on page 26 of
the manual. If you do not want to
be cutting in bypass mode turn
power switch off and back on.
Turn off main switch and saw should
operate in normally.
Turn the power switch off. Make
sure the bypass switch is not stuck
in the "ON" position.
Check that an unused Activation
Cartridge is in place in the active
position and that the plug is con-
nected securely.
Have the switch replaced by an Au-
thorized Bosch Service Center.
9/14/15 1:51 PM