Tools Needed For Assembly - Bosch GTS1041A Instrucciones De Funcionamiento

MOLDING
A non-through cut which produces a special
shape in the work piece used for joining or deco-
ration.
NEAR FIELD COMMUNICATIONS (NFC)
A wireless technology for communicating be-
tween enabled devices such as smart phone.
This tool is NFC enabled.
NON THROUGH-CUTTING
Any cutting operation where the blade does not
extend through the work piece (e.g. Dado, Rab-
bet).
PUSH BLOCK
A device used for ripping-type operations too
narrow to allow use of a Push Stick. Use a Push
Block for rip widths less than 2 inches.
PUSH STICK
A device used to feed the work piece through the
saw during narrow ripping-type operation and
helps keep the operator's hands well away from
the blade. Use the Push Stick for rip widths less
than 6 inches and more than 2 inches.
RABBET
A notch in the edge of a work piece. Also called
an edge dado.
Disconnect plug from power source before performing any assembly,
adjustment or repair to avoid possible injury.
FLAT SCREWDRIVER
COMBINATION SQUARE
1600A009XC 09-15.indb 8
REVOLUTIONS PER MINUTE (R.P.M.)
The number of turns completed by a spinning ob-
ject in one minute.
RIPPING
A cutting operation along the length of the work
piece cutting the work piece to width.
RIVING KNIFE OR SPREADER
A device that keeps the kerf of the work piece
open as the material is cut. This minimizes the
potential of the work piece binding against the
saw blade.
SMART GUARD
A system made up of 3 components: Riving Knife
or Spreader, Anti-Kickback Pawls, and Main Bar-
rier Guard.
THROUGH-CUTTING
Any cutting operation where the blade extends
through the workpiece.
WORK PIECE
The item on which the cutting operation is be-
ing performed. The surfaces of a work piece are
commonly referred to as faces, ends and edges.

Tools Needed for Assembly

PHILLIPS SCREWDRIVER
BOARD ALONG THIS EDGE.
10 MM WRENCH
OR ADJUSTABLE WRENCH
8
COMBINATION SQUARE MUST BE TRUE
STRAIGHT EDGE OF BOARD
3/4" THICK. THIS EDGE
DRAW LIGHT LINE ON
SHOULD BE NO GAP OR OVERLAP
HERE WHEN SQUARE IS FLIPPED
OVER IN DOTTED POSITION.
MUST BE PERFECTLY
STRAIGHT.
9/14/15 1:51 PM