Publicidad
Idiomas disponibles
Idiomas disponibles
Harness strap
Always use the Shoulder Harness Strap when using the
machine.
1. Attach the Shoulder Harness Strap to the Shoulder
Harness Strap fixing accessory;
2. Adjust the strap so that the left hand can comfortably
hold the handle at approximately waist height;
3. Make sure the couplings are secure.
OPERATING INSTRUCTIONS
When using the machine, you should take into
consideration some care and procedures of use in order
to avoid accidents, damage and to increase the
efficiency of the machine:
▪ Ensure that the machine is started at a distance of
more than 3m from the supply local;
▪ Always hold the machine with both hands and keep
it on the right side of your body;
▪ Keep the cutting accessories below waist level, thus
reducing the risk of being hit by projected objects
during operation.
▪ Do not use the machine to cut branches or logs or
wood. If you try to cut logs above the recommended
size, the machine may regress and cause accidents to
the user;
▪ When the machine is on idle speed, the cutting
accessory is not rotating. Otherwise, contact
technical assistance to make an inspection and solve
the problem;
▪ If you hear an unusual noise or the brush cutter
vibrate abnormally, stop working and identify the
cause;
▪ Never use the machine without the protection of the
cut accessories placed or damaged.
Engine start-up
1. Close the air control valve. Move the CHOKE lever
until it touches the top;
If the engines are warm or the air temperature is high,
do not close the air control valve.
2. Press the carburetor pump several times until the
pump is filled with petrol. Check that the fuel tube is full,
then the carburetor is filled with fuel.
3. Set the "ON/OFF" switch to position (I);
4. Press the safety switch and the throttle lever
simultaneously. Press the lock button to lock the
throttle;
5. Hold the machine with one hand and pull the handle
of the starter. Pull slowly until you feel some resistance,
then pull hard until the engine starts to run;
6. After the engine is started, the machine operates at
an intermediate speed between idle speed and
maximum speed. If you want to run the engine at idle
speed, press and release the throttle lever;
7. A few seconds after the start, open the air control
valve. Move the CHOKE lever until it touches the bottom
of the air.
When the starter handle returns to the original
position, the hand and arm can be moved quickly
towards the combustion engine.
Let the engine warm up at idle speed for a few
seconds before using it.
Stop the engine
1. Release the throttle lever and set the "ON/OFF"
switch to position (0);
2. If the throttle is locked with the locking button, press
and release the throttle lever;
3. Set the "ON/OFF" switch to position (0);
In case of imminent danger or emergency, stop the
engine immediately. Set the "ON/OFF" switch to "0";
Adjusting the engine speed
After starting, the engine is running at an intermediate
speed between idle and maximum speed.
When using the machine in continuous mode, with the
throttle lock button pressed, the engine runs at
constant intermediate speed.
The engine speed is set by means of the throttle lever.
1. If the throttle lever is not pressed, the engine runs
idle speed;
2. With the throttle lever fully pressed, the engine
reaches maximum speed;
Adapt the engine speed to the type of work you are
going to do. Remember, the higher the engine speed,
the greater the noise and fuel consumption.
40
Publicidad
