Publicidad
Idiomas disponibles
Idiomas disponibles
For good performance, the spark plug should be clean and
properly gapped between the electrodes.
1. Remove the spark plug cap, unscrew the spark plug with
the supplied key and check that it is clean;
2. Measure the distance between the electrodes with a
suitable tool. The distance must be between 0.7-0.8 mm.
If necessary, fold the electrode until the appropriate
slack is reached;
3. Install the spark plug and tighten firmly
may damage the engine;
4. If the spark plug does not spark when starting, replace
it.
To tighten/loosen the spark plug, use the supplied
spark plug wrench.
1.
.
Failure to do so
Gap between electrodes
0.7 – 0.8
Use the adjustment bolt on the throttle cable near the
handlebar support.
To adjust the drive cable, there are two adjustment bolts.
The bolt (12) attached to the drive lever and the bolt located
on the cable near the handlebar support (for a more precise
adjustment).
Clean the machine thoroughly after each use. Careful
handling protects the machine and increases its service
life.
Before cleaning, allow the machine to cool down
completely, remove the spark plug cap. When cleaning,
wear long-sleeved clothing and tight-fitting gloves.
Publicidad
