Publicidad
Idiomas disponibles
Idiomas disponibles
1. Adjust the belt cover (15) in accordance with the holes
for the fastening bolts;
2. Fit the rubber buffers and tighten the fixing bolts.
Assembly
1. Insert the shaft of the 4-blade set into the shaft of the
set with 2 sets of 4 blades;
2. Place and tighten the bolt with washer and nut;
3. Insert the side disc shaft into the tines' shaft with 1 set
of 4 blades;
4. Place and tighten the bolt with washer and nut;
All blades must be facing the same direction, check
the indications glued on the shafts with the
indication of the corresponding side of each set of blades
(R, L).
Placing the tines into the drive shaft
5. Fit the tines' shaft onto the drive shaft in the direction
indicated by the arrow () stamped on the tine;
6. Fit the pin in the innermost hole of the tines' shaft and
drive shaft. Insert the R-clip.
The tines must be oriented with the cutting edge
facing forward.
1. Remove the clevis pin with R-clip from the fixed farming
tools holder fitted in the gearbox;
2. Fit the furrow opener into the fixed farming tools holder;
3. Insert the clevis pin and the R-clip;
4. Adjust the furrow opener inclination in the adjustment
screws;
5. Insert the depth rod into the farming equipment holder;
6. Place the fixing pin in one of the holes of the depth rod
according to the desired height. Insert the R-clip;
7. Adjust the width of the furrow, in the adjustment screws.
1. Remove the locking pins from the fixed farming tool
holder;
2. Fit the depth rod holder into the middle hole of the fixed
farming tool holder. Insert the clevis pin and the R-clip;
3. Insert the depth rod into the farming tools holder. Place
the clevis pin into one of the holes of the depth rod
according to the desired height and insert the R-clip;
4. Adjust the inclination of the depth rod at the adjustment
screw;
5. Adjust the angle of the farming tools holder on the two
adjusting screws.
Publicidad
