In the event of an emergency
To stop the engine, place the throttle adjustment knob (8)
on the "STOP" position.
Under normal operation
1. Release the drive lever (11) and set the gear shift lever
(13) to neutral position "0";
2. Move the throttle knob (8) to "STOP" position;
3. Close the fuel supply, place the fuel tap (22) against the
left-hand side.
Before any maintenance and cleaning tasks, remove
the spark plug cap.
An engine running with low oil level will cause severe
engine damage.
1. Place the tiller on a flat floor;
2. Remove the oil filler cap (cap + dipstick) (17);
3. Check the oil level;
4. If the level is low, add oil (15W40) until the appropriate
level is reached;
To change the oil:
5. Remove the oil drain plug and empty all the oil;
6. Tighten the oil drain plug and add new oil;
7. Check the oil level and top up to the correct level.
1. Place the tiller on a flat floor;
2. The gearbox oil must be levelled with the lower limit of
the gearbox oil cap (19);
3. If the level is low, add oil (80W90) until the proper level
is reached.
Gearbox oil cap
Air filter with oil
1. Loosen the wing nut and remove the filter cap (5);
2. Remove the cap;
3. Remove the filter element;
4. Blow out the filter element with compressed air until it is
completely clean;
5. Fill with fresh oil (15W40) on the cup to the suitable
level;
6. Place all filter element in the filter and assemble the
remaining components in reverse order to disassembly.