Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
CONNECTING iNLET HOSES
CONNECTING
INLET HOSES
To produce
steam,
the
dryer
must
connect
to
the
cold
water
supply.
Since the washer
must
also connect
to the cold water,
a "Y" connector
is inserted to allow both inlet hoses to make that
connection
at the same time.
NOTE: Use the new inlet hoses provided; never use
old hoses.
1. Turn the
cold
water
faucet
off. Remove
the
washer
inlet
hose from
the washer
fill valve
connector
(cold).
2. Ensure the rubber flat washer
is in place and
screw the female coupling
of the short hose onto
the washer fill valve connector.
Tighten by hand
until firmly seated.
3. Attach
the female
end of the "Y" connector
to
the male coupling
of the short hose. Ensure the
rubber flat washer
is in place. Tighten by hand
until firmly seated.
.
S.
.
Insert
the filter screen
in the coupling
of the
washer's
inlet hose. If a rubber flat washer
is
already
in place remove
it before installing
the
filter screen. Attach this coupling to one male end
of the "Y" connector.
Tighten by hand until firmly
seated.
Ensure the
rubber flat washer
is in place and
attach
the dryer's
long inlet hose to the other
male end of the "Y" connector.
Tighten by hand
until firmly seated.
Ensure the
rubber flat washer
is in place and
attach
the other
end of the dryer's
long inlet
hose to the fill valve connector
at the bottom
of
the dryer back panel. Tighten by hand until firmly
seated.
CONNECTING
INLET HOSES (cont.)
J
7. Using pliers, tighten all the couplings with an
additional
two-thirds
turn.
NOTE: Do not overtighten. Damage to the couplings
may result.
8, Turn the water faucet on.
9. Check for leaks around the "Y" connector,
faucet
and hose couplings.
WATER SUPPLY REOUIREMENTS
Hot and cold
water
faucets
MUST be installed
within
42 in. (107 cm) of your
washer's
water
inlet. The faucets MUST be 3/4 in. (1.9 cm) garden
hose-type
so inlet hoses can be connected.
Water
pressure MUST be between 10 and 120 pounds per
square inch. Your water department
can advise you
of your water pressure.
NOTE: A water softener
is recommended
to reduce
buildup of scale inside the steam generator
if the
home water supply is very hard.
17
Publicidad
