Descargar Imprimir esta página

GE Profile PFDS450 Manual Del Propietario E Instalación página 10

Publicidad

Idiomas disponibles

Idiomas disponibles

About cycleoptions.
NOTE: Not all features are available on all dryer models.
.Lg:- D RUM
LIGHT
SETTINGS ÷
(
Press & hold for 3
seconds for secondary
options
Settings
Under
the
adjust
the
the display.
VOLUME
SETTINGS option,
you
can
volume
or the
brightness
of
[] End of Cycle (signal) volume can be set from
HIGH, MED, LOW or OFF.
[] Control Sounds volume can be set from
HIGH, MED, LOW or OFF.
DISPLAY BRIGHTNESS can be set from HIGH,
HED or LOW.
After you have made your selection, press
ENTER.
NOTE: To access
the SETTINGS menu,
hold
down the DRUM LIGHT button
for 3 seconds.
About dryer features.
Drum Lump
Before replacing the light bulb, be sure to unplug the dryer power cord or disconnect the dryer at
the household distribution panel by removing the fuse or switching off the circuit breaker. Reach
above dryer opening from inside the drum. Remove the bulb and replace with the same size bulb.
Engage the handle posts
Built-In
Rack Dry System
A handy drying rack may be used for drying items such as tennis shoes. Place items flat on the
drying rack and block such items as wool sweaters and delicate fabrics. Dry with low heat.
To install the Built-In Rack Dry System
1. Hake sure the drum of the dryer is oriented so the rack drying system is on the left side of the
dryer.
2. Pull the drying rack screen out from the left side and engage the handle "posts" in the
opposite baffle slots.
3. Place the garment on the rack and close the door.
4. Press the DRYERRACK button.
5. Select desired time.
6. Press the START/PAUSEbutton.
NOTE:
[] Do not use this drying rack when there are other clothes in the dryer.
[] Hake sure to detach the drying rack at the end of the cycle and fully retract the screen back
into the baffle.

Publicidad

loading