Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
[]
INSTALL BRACKET TO DRYER
A. Align the holes in the left bracket with the holes
in the bottom
left corner
of the dryer. Use a
Phillips screwdriver
to install
the 2 #12 x 1"
tapping screws.
B. Repeat the above step with the right bracket on
the bottom
right corner of the dryer.
C. Set the dryer upright.
NOTE: Hake sure to set the dryer on a piece of
packing material so the brackets that are attached
to the bottom of the dryer do not damage the floor.
.....
o
[]
INSTALL DRYER AND BRACKET ON
WASHER
A. Lift the dryer on top of the washer.
Be careful
not to scratch
the top of the washer with the
brackets.
Protect the washer control panel with
cardboard
or other protection.
Be sure to lift the
dryer high enough to clear the washer control
panel.
WAR N ING
-
Potential
Personal
Injury.
More than two people are recommended
to lift the dryer into position
because of its weight
and size. Failure to do so could result in personal
injury or death.
B. Align the holes in the bracket
with the holes
in the
back of the
washer.
Using
a Phillips
screwdriver,
attach
the
2 #8 x 1/2" tapping
screws. Repeat on both sides of the washer.
LJ
kJ
rsl FINALIZE THE INSTALLATION
A. Refer to the washer
Installation
Instructions
to
complete
the washer installation.
B. Refer to the dryer
Installation
Instructions
to
complete
the dryer installation.
C. Carefully slide or walk the stacked washer and
dryer into place. Use felt pads or other sliding
device to assist moving and to protect flooring.
WAR N ING
-
Potential
Personal
Injury.
Do not push on the dryer once installed
to
top of the
washer.
Pushing
on the
dryer
may
result in pinched fingers.
Place
hands
here
J
Place
hands
_--here
42
Publicidad
