Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
CONNECTING
AN ELECTRIC DRYER (cont.)
CONNECTING
DRYER USING 3-WIRE
CONNECTION
If required, by local code, install external ground (not
provided) to grounded metal, cold water pipe, or other
established ground determined by a qualified electrician.
Hot Wire
Screw
3 #10 AWG
minimum
Ground,
Strap
Green
(white)
Hot
Screw
3/4" UL
Strain
Recognized
Relief
Strain Relief
Bracket
conductors or
120/240V 50A
power supply
cord kit marked
for use with
dryers and
provided with
closed loop or
spade terminals
with upturned
ends (not
supplied)
3-wire
Connection
Not for use in Canada.
DO NOT use for Mobile Home Installations.
NOT for use on new construction.
NOT for use on recreational
vehicles.
NOT for use in areas where local codes prohibit
grounding
through the neutral conduction.
CONNECTING
DRYER USING 3-WIRE
CONNECTION
(cont.)
1oTurn off the circuit
breaker(s) (30 amp) or remove
the dryer's circuit fuse at the electrical
box.
2. Be sure the dryer cord is unplugged
from the wall
receptacle.
3, Remove the power cord cover located at the lower
back.
4, Install 3/4-in. UL-recognized
strain relief to power
cord entry hole. Bring power cord through
strain
relief.
5o Connect power cord as follows:
A. Connect the 2 hot lines to the outer screws of
the terminal
block (marked L1 and L2).
Bo Connect the neutral (white) line to the center of
the terminal
block (marked N).
6. Be sure ground
strap
is connected
to
neutral
(center) terminal
of block and to green ground
screw on cabinet
rear. Tighten all terminal
block
screws (3) securely.
7, Properly secure power cord to strain relief.
8, Reinstall the cover.
WARNING - NEVER
LEAVETHE
COVER OFF OF THE TERMINAL BLOCK.
24
Publicidad
