Publicidad
Idiomas disponibles
Idiomas disponibles
GEAppliances.com
tDry Tamp
¢ou can change the temperature
of your dry cycle.
ANTI-BACTERIAL
This option may only be used with COTTONS or MIXED LOAD cycles. This option reduces certain types of bacteria by
99.9%, including: Staphylococcus oureus, Pseudomonas aeruginosa and Ktebsiella pneumoniae*. The anti-bacterial
process occurs when high heat is used during a portion of this drying cycle.
NOTE: Do not use this cycle on delicate fabrics.
* The Anti-Bacterial Cycle is Certified by NSF International (formerly National Sanitation Foundation) to NSF Protocol
P!54 Sanitization Performance of Residential Clothes Dryers.
NSF Protocol
P154
Sanitization
Periormance
of
Residential
Clothes
Dryers
HIGH
For regular to heavy cottons.
MEDIUM
For synthetics, blends and items labeled permanent press.
LOW
For delicates, synthetics and items labeled Tumble Dry Low.
EXTRALOW
For lingerie and special-care fabrics.
START/PAUSE
Press to start a dry cycle. If the dryer is running, press it once and it will pause the dryer. Press it again to resume the dry
cycle.
Mv_
My Cycle (onsomemodels)
YCLE
S*o._MvCvcLE* Set up your favorite
combination
of settings and save them here for one touch recall. These custom
settings
can be set while a cycle is in progress.
To store a NY CYCLE combination
of settings:
1. Select your drying cycle.
2. Change DRY TEMP and SENSOR DRY settings to fit your needs.
21. Select any drying OPTIONS you want.
4. Press and hold the MY CYCLE button for 5 seconds to store your selection. A beep will sound the button will light up, and
the unit will display "Hy cycle is now programed
with the current cycle settings".
To recall your
stored NY CYCLE combination:
Press the NY CYCLE button
before drying a load. The light in the center of the button will light up when MY CYCLE is selected.
To change your
stored MY CYCLE combination:
Follow Steps 1-4 in "To store a MY CYCLE combination
of settings."
ODisplay
Special
Cycle Status
OR
Est. Cycle Time
g
Dryer Rack OR Timed Dry
OR Time to Dry
After the POWER button is pressed, the CLEAN
LINT FILTER message could appear if the
previous cycle was not finished. This message
will disappear after the STARTbutton is pressed.
Even though you have already cleaned the
filter (before the POWERbutton was pressed),
the CLEAN LINT FILTER message will still be
displayed until the STARTbutton is activated.
Del ]y Time
Lint Filter Status DELAYTIME
Status
Screen
"CLEAN LINT FILTER" (message)
This message appears periodically. It is only a reminder.
Publicidad
