GE Profile PFDS450 Manual Del Propietario E Instalación página 36

Installation Instructions
REVERSING THE DOOR SWING (if desired)
[] REVERSE DOOR HANDLE AND CAPS
A Lay the chrome cover down on a soft, protected,
flat surface so that the inner part faces upward
(resting on the handle side). Disassemble the
door cap from the chrome cover on the handle
side by removing 2 screws (#8 × 0.625" tapping
screws).
2xD
Screws
Door cap
B Disassemble the outer handle from the inner
handle by removing 3 screws (#8 x 0.625" tapping
screws). Disassemble the inner handle from the
chrome cover by removing 4 screws (#8 x 0.625"
tapping screws).
3xD
Screws
o• (Outer
•Remove
4x
Inner
handle
[_] REVERSE DOOR HANDLE AND CAPS
(CONT.)
C Pop the 2 handle caps out toward you and
reassemble on the opposite side of the chrome
cover, where you removed the outer handle.
D Assemble the inner handle onto the opposite
side of the chrome cover, using 4 screws (#8 x
0.625" tapping screws).
Inner
handle
36