Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
REVERSING THE DOOR SWING (if desired}
REVERSE HINGE AND CAPS {CONT.)
, Assemble
the hinge to the opposite
side of the
inner door, using 4 screws (#8-32 x 0.50" machine
screws).
, Assemble the new inner door cap (from reversibility
kit) on the opposite
side of the
hinge,
using
2
screws (#8 x 0.75" tapping
screws).
, Install the the screws,
nuts and washers
on the
opposite side of the hinge in the 2 remaining
holes.
, Flip the inner door so that the inner port faces down.
Reploce_
2×D
screws
door
cap
2 nuts and screws
2 washers
Assemble the inner cover (mask), be sure the snaps
have clamped the inner cover. Assemble the outer
window, be sure the 2 snaps have clamped the outer
window.
Inner cover \
FS]REASSEMBLE DOOR ASSEMBLY
Turn the inner door over
and
place
on
a
soft,
protected
flat
surface
so that the inner part is
facing
down.
Assemble
the chrome
cover to the
inner
door
by
placing
them
together.
Flip the
door
assembly
over and
assemble, using 7 screws
(#10
x
1.125"
tapping
screws).
[]
REVERSE FRONT PANEL PLUG
BUTTONS AND STRIKE PLATE
Remove the 2 plug buttons
on the dryer
front
panel, using a putty
knife or other
flat tool
as
shown, and reinstall on the opposite side. Switch
the strike bracket
and its cover by removing
2
screws (#8 x 0.625" tapping
screws) for each and
reinstalling
on opposite sides.
2 Plug
buttons
Protective
piece of tape
Strike
bracket
/
NOTE: Apply a protective
piece of tape to the side
of the plug button
where the putty
knife blade will
be inserted
to prevent
scratching.
38
Publicidad
