Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
INSTALLING THE PEDESTAL{if desired} {cont.}
[_
LEVEL THE WASHER OR DRYER
r_
stand
the washer
or dryer
upright.
Move it
close to its final location.
r_
Make sure that the washer or dryer is level by
placing a level on top. Check side to side and
front to back.
Use
an
open
ended
wrench
to
adjust
the
legs in and out.
Tighten
the
lock nut against
the
bottom
of
the pedestal.
NOTE: To minimize vibration,
the locking nuts must
be tight.
REMOVE
SHIPPING
SCREWS
Remove the 4 shipping screws on the back side of the
washer.
E_ FINALIZE THE INSTALLATION
Refer to the washer or dryer Installation Instructions
to complete the installation.
B]
B]
@
re]
@
REINSTALL
THE DRAWER
Check to be sure the slides are closed.
Slide the drawer
Drower
into the
Divider
opening. Align
the drawer
supports to the
slides on each
side.
Reinstall the
original screws
into each
drawer slide.
Tighten both
screws.
Open the drawer fully. Slide drawer divider
into slots in the center of the drawer. The
drawer should slide smoothly when you push
it closed.
45
Publicidad
