Publicidad
Idiomas disponibles
Idiomas disponibles
English
3. Using the dust collector (Optional accessory)
To use the vacuum cleaner to gather up saw dust,
attach the suction hose to the dust collector which is
attached to the main unit by M4 screw. (Fig. 22).
Dust collector
M4 screw
OPERATION
WARNING
● Never touch the moving parts.
● Never operate the power tool with the saw blade
turned upward or to the side.
● Do not fix and secure the lock-off button.
Besides, keep your finger off the trigger switch
when the power tool is being carried around.
Otherwise, the main body switch can be
inadvertently turned ON, resulting in unexpected
accidents.
● Do not use any abrasive wheels.
● Do not use any saw blades which do not conform
to the specified rating.
● The saw blade must be suitable for the no-load
speed.
● Use a saw blade that is suitable for the material
being sawn.
● Use only genuine metabo HPT saw blades. Saw
blades intended for cutting wood or similar
materials have to conform to EN 847-1.
● Use only blade diameter specified on the product
nameplate.
22
Loosen Tighten
45˚–55˚
Fig. 21
Fig. 22
● Should the saw blade be stopped or make an
abnormal noise during operation, turn off the
switch immediately.
● Always wear eye protection with side shields
that meets the requirements of ANSI Standard
Z87.1.
Ordinary eyeglasses do not provide adequate
protection.
● Avoid cutting any material like metal, etc., that
give off sparks.
CAUTION
● To extend the lifetime, the lithium-ion battery
equips with the protection function to stop the
output. Therefore, if the tool is overloaded, the
motor may stop. However, this is not the trouble
but the result of protection function. In this case,
release the switch of tool and eliminate the
causes of overloading.
● Before use, check to see if the lock-off button
moves smoothly.
● Take care not to lock the motor. If the motor is
locked, immediately turn the power off. If the
motor is locked for a while, the motor or battery
may be burnt.
1. Check if saw blade is tightened
For further details, refer to the item of [2. Changing
saw blades] on page 19.
2. Check if the levers are tightened (Fig. 19, 20)
If the cutting depth and incline lever are loose, injury
can result. Make sure that they are tightened
securely.
3. Check performance of lower guard
For further details, refer to the item of [3. Check
performance of lower guard] on page 20.
4. Check battery insertion
WARNING
If the battery is inserted while the power switch
is in the ON position, the power tool will start
operating immediately, inviting serious accident.
CAUTION
Until the battery locks in place with a little click,
if not, it may accidentally fall out of the tool
causing injury to you or someone around you.
5. Operation of switch (Fig. 23)
For safe operation of the machine, a "lock-off button"
is provided on the side of the handle.
Publicidad
