Publicidad
Idiomas disponibles
Idiomas disponibles
English
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it
to fully cool down.
Blinks ;
Output suspended due to failure or
malfunction. The problem may be the battery
so please contact your dealer.
As the remaining battery indicator shows somewhat
differently depending on ambient temperature and battery
characteristics, read it as a reference.
CAUTION
Do not give a strong shock to the display panel
or break it. It may lead to a trouble.
9. How to use the LED light (Fig. 25)
This product features LED interlock function that
means the LED with turn ON/OFF automatically
depending on the products power ON/OFF.
LED Light
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
10. LED light warning signals
This product features functions that are designed to
protect the tool itself as well as the battery. If any of
the safeguard functions are triggered during
operation, the LED light will blink as described in
Table 6. When any of the safeguard functions are
24
Fig. 25
triggered, immediately remove your finger from the
switch and follow the instructions described under
corrective action.
Safeguard
Function
On 0.1 second/
Overload
off 0.1 second
protection
On 0.5 second/
Overheat
off 0.5 second
protection
11. Attaching the guide (Sold separately) (Fig. 26, 27)
Install the wing bolt (B) and lock spring on the base.
Insert the guide into the base, move it left and right
and adjust the cutting position. Tighten the wing bolt
(B) and fix the guide.
The guide can be installed either from the left or the
right side of the main body.
Wing Bolt (B)
Lock Spring
Base
Wing Bolt (B), Lock Spring
WARNING
When using the guide, avoid inclined cutting that
will allow the cut material to be caught between
the saw blade and the guide. Doing so may result
in injury.
Table 6
LED Light
Corrective Action
Display
Remove the
cause of the
overburdening.
Allow the tool
and battery to
thoroughly cool.
Fig. 26
Base
Guide
(Rip Fence)
Fig. 27
Publicidad
