Metabo HPT C 3607DB Manual página 30

English
WARNING
● To avoid injury from an accidental start, turn the switch OFF and pull out the battery from the power
source or remove the battery from the main body before making any adjustments.
● All electrical or mechanical repairs should be done only by qualified service technicians. Contact
metabo HPT Authorized Service Center.
1. Power tool
Problem
Tool doesn't run
Tool suddenly stopped
Cannot be inclined
Doesn't cut well
Switch can't be pulled
Sawdust discharge is poor
Battery cannot be installed
30
TROUBLESHOOTING GUIDE
Possible Cause
No remaining battery power
Battery isn't fully installed.
The trigger switch was held down
while the battery was inserted.
Tool was overburdened
Overload protection is in operation.
The battery is overheated.
The trigger switch was held down for
5 minutes or more.
The incline lever is not loosened.
The saw blade is worn or missing
teeth.
The bolt is loose.
The saw blade is installed backwards. Install the saw blade in the proper
The lock-off button is not pushed in
enough.
Sawdust has accumulated in the saw
cover.
Attempting to install a battery other
than that specified for the tool.
Possible Solution
Charge the battery.
Push the battery in until you hear a
click.
The safety function was activated. If
the trigger switch is released once
and then pulled again, the tool will
run.
Get rid of the problem causing the
overburden.
Let the battery cool down.
This is not a malfunction.
The motor was automatically stopped
to prevent failure of the tool.
Try inclining after loosening the
incline lever. Tighten the loosened
parts after making the necessary
adjustments.
Replace with a new saw blade.
Firmly tighten the bolt.
direction.
Push the lock-off button in all the way.
Remove the sawdust inside the saw
cover.
Please install a multi volt type battery.