Metz mecablitz 26 AF-1 digital Manual De Instrucciones página 100

Some cameras support the AF auxiliary light
flash unit only with the camera's central AF sensor.
9 Triggering control (auto-flash)
On some cameras, the flash will not be fired when the
prevailing light is sufficient for an exposure. When the
camera shutter release is depressed, no flash exposure
is triggered.
In various cameras, the triggering control only works
in the full program mode or "P" program or must be
activated on the camera (see camera operating
instructions).
k
100
10 Care and maintenance
in the
Remove any dirt and dust with a soft, dry cloth. Do not
use any cleaning agents – plastic components could be
damaged.
10.1 Firmware updates
The firmware for the flash unit can be updated via the
USB socket
future cameras (firmware update).
Checking the software version
• Switch off the flash unit; to do this, press button
until all LED displays turn off.
• Switch on the flash unit while holding down the
"TTL" button, then release the button.
The "TTL" button on the flash unit blinks, followed by
the "SLAVE" button
The number of blink pulses indicates the software
version; for example, if the "TTL" button
and the "SLAVE" button
version 1.3 is installed.
For more information, visit the Metz homepage at
www.metz.de.
and can conform to the functions of
.
blinks 3 times, software
blinks once