Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
4
Once the combustion head adjustment is completed:
reassemble the burner on the guides 3) at about 100 mm
from the pipe coupling 4) - burner in the position shown in
Fig. 11;
insert the probe and electrode cables, then slide the burner
as far as the pipe coupling - burner in the position shown in
Fig. 17;
connect the socket of the maximum gas pressure switch;
refit the screws 2) on the slide bars 3);
20032905
2
3
fix the burner to the pipe coupling with the screws 1).
re-couple the articulated coupling 7) to the graduated
sector 6).
When fitting the burner on the two guides, it is
advisable to gently draw out the high voltage cable
and flame detection probe cable until they are
slightly taut.
CAUTION
4
D8691
14
GB
5
1
6
7
Fig. 17
Publicidad
