Hilti Nuron SI-AT-22 Manual De Instrucciones página 29

Status
2 short tones
4 short tones
3.7 USB interface
The USB interface (type C, USB 2.0) can be used to connect the torque module to a PC. When this connection
is made, the AT Documentation Software offers a range of functions, including:
• Adding new data records for new fasteners
• Changing / updating existing data records
• Deactivating / activating the documentation function
• Loading the log from the documentation function
• Setting the clock in the torque module
Further information can be found in the documentation for the AT Documentation Software.
The software can be downloaded from here:
http://www.hilti.com/adaptive_torque_documentation_software
3.8 Items supplied
Adaptive torque module, operating instructions, quick-start guide, USB cable
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4 Technical data
Weight
Laser class
Scanner type
USB interface
5 Preparations at the workplace
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Inserting torque module
WARNING
Risk of short circuit !
▶ Before inserting the torque module, make sure that the contacts on the torque module and the contacts
on the impact wrench are free of foreign matter.
WARNING
Risk of injury by a falling torque module !
▶ Check that the torque module is secure on the impact wrench.
*2343813*
Meaning
Warning tone 1
•
•
Warning tone 2
•
•
•
2
2343813
OK or not OK, as applicable, depending on
the fastener and the application (e.g. repeat
torquing of a fastener, tightening torque not
detected. See the section headed Tightening
the threaded fastener in "Adaptive" operating
mode)
The LEDs flash yellow.
Not OK
Operation canceled
The LEDs flash red.
0.24 kg
(0.529 lb)
1
Camera / scanner (imager)
Type C, USB 2.0
English 25