Hilti Nuron SI-AT-22 Manual De Instrucciones página 30

▶ Push the torque module on to the impact wrench from the front until it engages with an audible click.
5.2 Inserting the battery
WARNING
Risk of short circuit !
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the torque
module are free of foreign matter.
WARNING
Risk of injury by a falling battery !
▶ Check that the battery is secure on the torque module.
▶ Push the battery on to the torque module from the front until it engages with an audible click.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Removing torque module
1. Remove the battery.
2. Press and hold down the release button (2) of the torque module.
3. Pull the torque module forward and off the impact wrench (3).
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Switching on and off
6.1.1 Switching on the torque module
Conditions: The torque module is switched off, the display is blank.
1. Set the forward/reverse switch on the impact wrench to the "forward" position.
2. Short-press the control switch on the impact wrench.
▶ The display lights up and briefly shows the
▶ As a function check the LEDs briefly show red and yellow, before turning green. An acoustic signal
sounds.
▶ The last operating mode selected appears inside a selection frame on the display.
▶ If the display shows a fault:
▶ Refer to the Troubleshooting section for the meaning of the icon or icons shown on the display.
3. Select the operating mode and other settings, as applicable. → page 30
4. Press the lock button
▶ The torque module is locked and the impact wrench is ready for use.
6.1.2 Switching off the torque module
The torque module switches itself off:
• when the impact wrench switches off automatically after a long idle period
• when the battery is removed
• when the USB connection between the torque module and the PC is interrupted.
6.2 Basic operation
This section explains the most frequently used basic functions in order to illustrate how the module
is used. Detailed descriptions of certain operating modes can be found in the sections covering the
specific operating modes.
26 English
2
3
.
start screen.
2343813
*2343813*